1. The sealing machine pinching action is too slow or the pinning stroke is insufficient: the bolt is loose, the front buckle or the inner piece of the plate machine is worn. At this time, the bolt can be tightened, pay attention to the correct position of the front buckle shaft, and the front buckle can also be replaced. Or the inner part of the board machine, after completing the above actions, test its function. If the stroke is too short, fine-tune the front buckle shaft upwards. If the motion is slow, fine-tune the front buckle shaft downwards;
2. Air leakage at the piston rod of the sealing machine: the bottom ring of the main body is damaged, and the ring should be replaced at this time;
3. Leakage of the exhaust port of the sealing machine: the switch valve ring or the switch seat ring is damaged or the piston ring is damaged. Replace the ring;
4. Leakage at the trigger of the sealing machine: the switch valve ring or the switch seat ring is damaged. Replace the ring;
5. The sealing ring of the sealing machine can not be positioned: the plastic steel strip and the transmission spring are inelastic, the combination of the laminating machine is removed, and the spring end is reinstalled or the plastic steel strip and the transmission spring are replaced.
Concerned about surprises
Label: Sealing machine failure and solution
Previous: Daily use and maintenance of water purifier products Next: How to properly use and maintain electronic balances
D-rings offer another alternative Seal solution to O-rings for use in reciprocating dynamic or rotary applications. They offer the same sealing characteristics as an O-ring and can be used in both low and high pressure application across a broad range of temperatures.
D-rings can typically be retrofitted into existing O-ring grooves with the size often based around the original O-ring size. The flat geometry on the base of the D-ring stops the seal from twisting and rolling, preventing spiral failure often seen when O-rings are used in reciprocating applications. D-rings can be manufactured to standard O-ring sizes, as well as custom sizes for specific applications.
D Rings Seal,D Shaped O Ring,D Shaped O Rings,D Stops Rubber O Rings
Shenyang Guide Rubber Products Co.,Ltd , https://www.guiderubber.com