Common problems of computer gong spindle:
1. The main shaft is not perpendicular to the work surface. This problem can be seen from the different depths of the lower knife and the closed knife. At this time, the spindle needs to be corrected again.
2. The failure of the motor of the main shaft will lead to different levels of engraving.
3. Reasons for spindle stall:
Data line short circuit;
Control card failure;
The parameter setting is wrong;
Current shielding
Spindle internal short circuit
4. The abnormal rotation sound may be caused by damaged bearings or incorrect settings of the inverter.
5. Spindle rotation can't stop: it may be a problem with the control card or the inverter
6. Reverse rotation of the spindle: check the parameter setting of the inverter and the connection of the signal line
7. Stopping or rotating too slowly may be unstable operating voltage or overload. In this case, a voltage regulator should be added. Most of the failures of the computer gong spindle are the above points, I hope that the editor's summary can help you complete the work better.
================================================== ================================================== ======
Miss Pan, 18566164006
Bimetallic Screw Barrel,Barrel Bimetal,Bimetallic Barrel,Bimetallic Screw
Zhoushan Jinsheng Bimetallic Plastic Machinery Factory , https://www.jinshenggalloy.com